Male Rigid 45' SAE x Push-on Hose Barb
Item #: 6LOC-6RMS
Product Info
Specifications
- Number of Barbs: 2
- Barb Length: .92”
Features
- Notch in nut for SAE identification
Installation
- Assembly Instructions:
- 1. Trim hose end with smooth square cut.
- 2. Lubricate either push-on fitting, hose or both.
- 3. Insert push-on fitting into hose until first barb is in hose.
- 4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.
Instructions
- Disassembly instructions:
- 1. Leaving push-on fitting in place, make a 1” cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.
- 2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.
Item Specifications
-
UNF
-
5/8"-18
-
3/8"
-
3/8"
-
5/8"
-
1.83"
-
350 PSI
-
-40 to +150°F
-
0.074
-
Brass
-
Yellow Plastic Cap
-
0.08 lbs per
