Boss Clamp 4 Bolt Type, 2 Gripping Fingers

Use

• Bolts in Boss Clamps are designed to bend as they are tightened. This allows the clamp to conform to the hose outside diameter.
  
• Always tighten bolts to their specified torque value.
  
• Periodic re-tightening of bolts is required due to “cold flow” phenomenon present in all rubber hoses.
  
• Boss Clamps are for single use only! Once removed they are to be discarded.
  

Specifications

• Recommended for steam service up to 450°F (232°C).
  

Features

• 4-bolt type clamp with 2 gripping fingers and 2 clamp sections

Instructions

• 4 Bolt Dixon Boss Clamp Bolt Tightening Sequence, Using a torque wrench, begin tightening the bolts as follows:
  
• a) Back bolt (bolt with nut facing assembler that is furthest away from gripping finger) 1 full turn.
• b) Front bolt (bolt with nut facing assembler that is closest to gripping finger) 1 full turn.
• c) Snug by hand (if bolts are loose) nuts on opposite side of bolts just torqued.
• d) Opposite side back bolt (bolt with nut facing assembler furthest away from gripping finger) 1 full turn.
• e) Opposite side front bolt (bolt with nut facing assembler closest to gripping finger) 1 full turn.
• f) Snug by hand (if bolts are loose) nuts on opposite side of bolts just torqued.
• g) Repeat above procedure “a” through “f” until all of the bolts have reached the recommended torque.
  
• h) Remove assembly from vise.