Boss Clamp 2 Bolt Type, 2 Gripping Fingers
Item #: DIB4
Product Info
Use
- The correct size Boss Clamp must be used.
- Bolts in Boss Clamps are designed to bend as they are tightened. This allows the clamp to conform to the hose outside diameter.
- Always tighten bolts to their specified torque value.
- Periodic re-tightening of bolts is required due to “cold flow” phenomenon present in all rubber hoses.
- Boss Clamps are for single use only! Once removed they are to be discarded.
Specifications
- Recommended for steam service up to 450°F (232°C).
Features
- 2-bolt type clamp with 2 gripping fingers and 2 clamp sections
Instructions
- 2 Bolt Boss Clamp Bolt Tightening Sequence, Using a torque wrench, begin tightening the bolts as follows:
- a) First bolt (nut facing assembler) 1 full turn.
- b) Second bolt (opposite first bolt) 1 full turn.
- c) Repeat procedure “a” and “b” until both bolts have reached the recommended torque.
- d) Remove assembly from vise.
Item Specifications
-
1/2"
-
15mm
-
60/64"
-
23.8mm
-
1-4/64"
-
27.0mm
-
12 ft. lbs.
-
0.42
-
Global Investment Cast Carbon Steel
-
0.41 lbs per
